Electrical Diagram / September 18, 2017 / Mina Titus.
A board whose surfaces have printed current conductors with contact areas, which are used to connect components mounted on the boards according to the circuit diagram of a functional subassembly for electric or radio apparatus, and also have plated circuit holes and nonplated mounting holes. There are about 200 methods for making printed circuit boards; among the most important are the photochemical, photoelectrochemical, and offset-electrochemical methods. The methods differ in the means of producing the conductive coating or the form in which the pattern of the printed conductors is realized.
Block diagrams are widely used in all fields of engineering, management science, criminal justice, economics, and the physical sciences for the modeling and analysis of systems.
In design documentation, a document showing in conventional notation the components of an article or installation and the connections or links between components. Diagrams are usually drawn without regard to scale or to the actual spatial arrangement of the components. They may be classified according to the type of components and connections between components as electrical, pneumatic, hydraulic, kinematic, or combination diagrams. They may also be classified according to the purpose for which they will be used.
Because some circuits can be very complicated, and since even the simplest circuits may have complicated behavior, the area of computer-aided design (CAD) of electronic circuits has been extensively developed. A number of circuit simulation programs are available, some of which can be run on personal computers with good results. These programs rely heavily upon good mathematical models of the electronic devices. Fortunately, the area of modeling of electronic devices is well developed, and for many devices there are models that are adequate for most purposes. But new devices are constantly being conceived and fabricated, and in some cases no adequate models for them exist. Thus, many of the commerical programs allow the designer to read in experimentally obtained data for a device from which curve fitting techniques are used to allow an engineer to proceed with the design of circuits incorporating the device. Reproducibility and acceptability of parts with tolerances are required for the commerical use of electronic circuits. Consequently, theories of the reliability of electronic circuits have been developed, and most of the computer-aided design programs allow the designer to specify component tolerances to check out designs over wide ranges of values of the elements. Finally, when electronic circuits are manufactured they can be automatically tested with computer-controlled test equipment. Indeed, an area that will be of increasing importance is design for testability, in which decisions on what to test are made by a computer using knowledge-based routines, including expert systems. Such tests can be carried out automatically with computer-controlled data-acquisition and display systems.