Other Wiring / November 11, 2017 / Mina Titus.
The unshielded conductors radiate an electric noise field that couples capacitively with adjacent wiring. Stray capacitance at A & C cause ground currents to flow creating a magnetic noise field that couples inductively with adjacent wiring.
For wiring a single-phase motor, the most important objective is to distinguish the starting circuit from the main winding. These two circuits are isolated from one another electrically if the lead wires are separarted and not in contact with each other. Initially, the ohmeter can be used to determine which wire belongs to which circuit as well as checking continuity between leads.
Another interesting design is the brushless DC (BLDC) motor. The stator and rotor effectively swap over, with multiple iron coils static at the center and the permanent magnet rotating around them, and the commutator and brushes are replaced by an electronic circuit. You can read more in our main article on hub motors. Stepper motors, which turn around through precisely controlled angles, are a variation of brushless DC motors.
You should be able to isolate into two groups any leads which have continuity with one another. The starting circuit is likely to isolate to two leads, the running circuit may have two or more leads that show continuity. If the running circuit has more than two leads, you will need to determine how those leads are to be used for voltage or speed changes.